Publicité
pliance must stand firmly on the floor and be
as perpendicular as possible.
Level it accordngly. correcting any possible
irregularities in the floor.
This may be done by adjusting the height of
the feet at the bottom of the appliance (Figure
7) (0-20 mm).
A maximum 2% inclination level is allowed.
Door decoration
You can fit decorative panels to the door of
your DISHWASHER so that it matches the
surrounding decor.
This pannelling may be up to 4.5 mm thick.
Fitting the panels
1.- Remove the door frame from your dish-
washer by undoing the screws as shown
in Figure 3.
2.- Prepare the panel according to the mea-
surements given in Figure 3 (597 x 587
mm).
3.- Fit the panel you have chosen and screw
the frame back into place.
Once you have done this, proceed
with
the
water
supply connections according to the
instructions.
Built-in dishwashers
Introduction
Although they can also be used as free-
standing appliances, our BUILT-IN DISHWAS-
HERS are designed so that you can fit them
into your kitchen under the work surface.
You may easily adapt your dishwasher to the
decor and door alignment of the rest of your
kitchen by performing a few simple opera-
tions.
Dimensions
Figure 5 gives the measurements of your
dishwasher and the minimum requirements
for the kitchen units. These will help you in
the installation process.
and
electricity
If you want to put your dishwasher under the
kitchen work surface, you have to remove the
top cover by undoing the two screws shown in
Figure 4 and also remove the counter weight
located at the top of the machine. (Fig. 2)
You can use these same screws later to secure
your appliance to the kitchen work surface,
thereby ensuring the stability of the dishwas-
her.
Levelling and positioning
Refer to the section on levelling and positio-
ning for free-standing and panellable
dishwashers.
Door decoration
You can fit decorative panels to the door of
your DISHWASHER so that it matches the su-
rrounding decor.
This panneling may be up to 4.5 mm thick.
Panelling and adjusting the door
1.- Remove the door frame form your dish-
washer by undoing the screws as shwon in
Figure 6.
2.- Cut the decorative panel according to the
height required (h) to line it up with the
kitchen units either side.
3.- Take the door frame and cut it, by sawing off
the top ends, to the same height (h) as the
decorative panel.
4.- Adjust the lower door shim to the right
height (h).
5.- Fit the decorative panel to the door. At the
same time secure the frame and re-mark
the position of the new holes in the door.
Make the holes with a 3.25 mm drill bit.
Screw the frame back into place.
Note
If you want to fit your dishwasher into a row of
kitchen units with a single kickstrip, this is
possible, although you should bear the follo-
wing in mind:
1.- Remove the base (1) and the feet (2) by un-
doing the screws (according to Figure 1).
84
Publicité
Chapitres
