Cold Weather Start-Up; Remote Run Terminal Block - Wacker Neuson G 100 Notice D'emploi

Operation
4.23

Cold Weather Start-Up

Prerequisites Before starting the generator in cold weather make sure that:
the battery is at peak power
the correct weight motor oil is being used
the starter motor is in good condition
During The cold starting aid will automatically activate when the air temperature is low
operation
enough. The ECM will notify you that a preheat is in effect.
4.24

Remote Run Terminal Block

Location The remote run terminal block (i) is located just to the left of the convenience
receptacle circuit breakers.
i
Description The remote run terminal block provides connection points for installation of a
remote start switch. When it is connected to a transfer switch, it allows the
generator to be used as a stand-by power supply.
Connections When connecting a remote start switch or transfer switch, use the inner two
terminals on the remote run terminal block.
Note: The bonding bar between the ground connections must remain in place at all
times unless a qualified electrician determines otherwise.
wc gr005194
54
G 100 / G 120
wc_tx001687gb.fm