Voltage Selector Switch - Wacker Neuson G 100 Notice D'emploi

Operation
4.5

Voltage Selector Switch

Location The voltage selector switch is located inside the generator enclosure near the
engine air cleaner. To access the switch, open the rear door on the left side of the
generator enclosure.
WARNING
Possibility of electrocution! High voltage is present inside the machine enclosure
when the generator is operating!
Never open the access door while the generator is operating.
NOTICE: Do not change the voltage selector switch with the engine running. This
can cause arcing and can severely damage the switch and the generator windings.
Description The voltage selector mechanically changes the connections between the generator
output leads and the terminal lugs on the generator. This allows different voltage
ranges to be selected:
Operation Select the voltage range by rotating the handle on the voltage selector switch to
the desired voltage.
Locking the The voltage selector is equipped with a locking mechanism. This allows the
voltage
voltage setting to be locked in place to prevent unauthorized personnel from
selector
changing the voltage selection.
To lock the voltage selector switch in position, push the locking mechanism up
and attach a padlock through the openings in the locking strip.
Available Voltage Ranges
120/240 VAC 1Ø
120/208 VAC 3Ø
139/240 VAC 3Ø (Refer to section
Voltage Adjustment Rheostat.)
277/480 VAC 3Ø
120 / 208
3Ø
277 / 480 120 / 240
3Ø
wc_gr005686
38
G 100 / G 120
wc_tx001687gb.fm