WOLFF Weldmaster 2.0 230 V Traduction Du Mode D'emploi Original page 19

6.0 Trouble shooting
Fault Possible cause
Display not lit Power supply inter-
rupted, fuse, cable
or plug defective
Machine does Sensor linear
not start after guide (Fig. A pos.
draining the 12) not trigge-
heater fan red
Unit does not Heating element or
heat control defective
Instead of the Damage to the tem-
temperature, perature sensor
„Error Temp"
is displayed
7.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
.
Only for EC countries:
Do not dispose of power tools into house-
hold waste! According the European Guideli-
ne 2002/96/EC for Waste Electrical and
Electronic Equipment and its implementation
into national right, power tools that are no
longer usable must be collected separately and disposed
of in an environmentally correct manner.
Subject to change without notice
8.0 Guarantee
The warranty period for new Wolff machines shall last for
one year from the point at which the machine is transfer-
red / delivered to the customer, insofar as statutory legal
requirements do not stipulate otherwise.
When validating warranty claims, the invoice or proof of
purchase must always be submitted. All repairs within the
framework of the warranty agreement must be undertaken
Remedy
by a service Centre that has been accredited by us.
Customers performing their own repairs and/or improper
Have the fault rec-
repairs regularly lead to the exclusion of warranty claims.
tifi ed by a qualifi ed
The same also applies to incorrect operation and/or use.
electrician or repla-
ce the parts.
Replacement of parts, accessories and other modifi ca-
tions to Wolff machines
Check whether the
Users of Wolff machines enjoy a high level of safety and
sensor lights up
reliability of their machine. In order to maintain this status
when the heating air
quo, your Wolff tool may not be modifi ed from the condition
blower is drained,
in which it is delivered without following the rules below.
otherwise have it
replaced by a spe-
These rules apply to both the replacement of parts and
cialist workshop.
equipping the machine with accessories as well as other
Have the fault locali-
technical modifi cations.
zed and rectifi ed by
a specialist work-
shop
r All work undertaken to your Wolff machine must
Have temperature
sensor replaced in
specialist workshop
r In the event of planned replacement of parts, plan-
r It is highly recommend that only safety-approved
r In order to preserve operational safety and to pre-
Please note that we cannot accept any liability for
damage, insofar as this is sustained as the result of
incorrect work undertaken or as the result of violation
of the rules stated above.
be undertaken exclusively by a workshop that
has suitably trained and experienced personnel at
its disposal, as well as the requisite work equip-
ment. We recommend using authorised service
Centre.
ned addition of accessories or other planned
technical modifi cations, an assessment must al-
ways be carried out by an authorised service
Centre or us, as manufacturer, before work is com-
menced.
Original Wolff replacement parts and Original Wolff
accessories are used, which have been approved
by us, as manufacturer. Replacement parts and
accessories can be obtained from your authorised
service Centre, which will also be able to undertake
professional installation on your behalf. Original
Wolff replacement parts and Original Wolff acces-
sories have been checked for safety and suitability
especially for Wolff machines.
We are unable to adequately assess the safety and
suitably of non-Original Wolff replacement parts.
vent damage in the event of technical modifi cati-
ons, of whatsoever nature, our technical guidelines
must always be observed. We are also always
happy to hear from you should you have any other
questions about your Wolff machine.
EN
19