Festo CPX-MMI-1 Mode D'emploi page 19

Fitting onto a hat rail:
4. Fit the clip (3) onto the support type CPX−MMI−1−H (1)
with the M3x6 countersunk screws supplied. Tighten
ing torque max. 0.6 Nm.
5. Hang the support onto the hat rail.
1
Support
2
Fixing bolts
3
Clip
4
Hat rail
5
Clamping element
with locking screw
6. Secure the support with the clamping element (5) so
that it cannot tilt or slide down. In order to do this turn
the locking screw in a clockwise direction (see also
following diagram).
1
Hat rail
2
Clamping element
with locking screw
In order to loosen the clamping element again, turn the
locking screw in an anti−clockwise direction.
Festo CPX−MMI−1 0305NH English
1 2
3
4
5
1
2
19