Electrodes Installation - Nitty-Gritty CLINOX REC Manuel D'utilisation

4. ELECTRODES INSTALLATION

The electrodes of the Clinox REC are made of materials resistant to the electrolyte solutions and to the high temperature
reached during the working operation.
Pay attention: For the installation of the electrodes (24) is recommended to use gloves and it is necessary to unplug
the equipment from the mains.
Pay attention: check the correct combination of electrodes (24) and internal collectors (25) (Picture E).
Eectrode for flat surfaces (24a)
Electrode for external angles (24b) +
Electrode for internal angles (24c) +
Electrode for polishing (24d)
1. Disconnect Clinox REC from the mains.
2. Insert the desired electrode (24) in the special venue on the electrode bringer head (23).
3. Insert the internal collector (25) on the MIG torch (19) and fix it to the external collector (21) using the specific
O-ring (26).
24
23
+ internal collector for flat surfaces (25a)
internal collector for external angles (25b) +
internal collector for internal angles (25b)
+ internal collector for polishing (25d)
21
33
+ MIG Bond pad for flat surfaces (27a)
MIG Bond pad for external angles (27b)
+ MIG Bond pad for internal angles (27c)
+ MIG Bond pad for polishing (27d)
21
25
24
26