Maintenance; Ordinary Maintenance; Special Maintenance; Disposal And Scrapping - Nitty-Gritty CLINOX REC Manuel D'utilisation

10. MAINTENANCE

Pay attention: before any maintenance it is necessary to disconnect the equipment from the mains.
10.1. O
RDINARY MAINTENANCE
Pay attention: N
ITTY
Before every work shift:

Check the condition of the machine's components and replace them if necessary; use only original parts.

Check the condition of the electrical equipment and value its reliability during operation.
At the end of work shift clean the machine:

Remove the pad/brush (27/33/34) to prevent encrustations of the electrolyte on the tip due to evaporation and
corrosion on the electrode/insert (24/32). Whenever the pad/brush (27/33/34) is worn or burnt, replace it with a new
one before restart working. If the pad/brush (27/33/34) does not require replacement, rinse it out with water.

Once it has cooled down, clean the electrode/insert (24/32) and tip of the torch to prevent encrustations.
During the replacement of electrolytic solution:

Wash the tank (13) with water.

(*)
Replace the filter (Paragraph 3).
(*)
NOTE : Pay attention during the filter installation because the filter of MIG BOMAR (40) solution is
different to the filter of MIG BOMAR POLISHING (41) solution.
10.2. S
PECIAL MAINTENANCE
Extra-duty maintenance is generally effected by qualified technical of N
Pay attention: the N
not authorized people.

11. DISPOSAL AND SCRAPPING

Pay attention
: the user must pursue the maximum environmental protection.
PACKING
: this kind of waste is similar to the urban kind. It is therefore possible to dispose of it in the urban refuse
disposal sites without jeopardizing the environment or the population.
USED SPECIAL PADS
USED TANK FILTER : the disposal of special waste must be in compliance with the regulations in force.
DETERIORATED OR OBSOLETE MACHINERY
Special waste to be scrapped according to the machinery. With reference to the CE-2002/96 directive
concerning waste of electric al and electronic equipment (WEEE), during dismantling, the user must separate
the electrical and the electronic components and dispose them in the appropriate authorized collection centers
or give them back as they are to the seller, when a new purchase is made.
WASTE LIQUID
: during the process (cleaning and polishing) heavy metals are mixed with the waste liquids: thus the
liquids have to be considered as special waste and disposed following the regulation in force in the country where the
machine is used.
-G is not liable for the consequences if non original products are used.
RITTY
-G guarantee will fall if the product is dismounted repaired or in any case handled by
ITTY RITTY
: the disposal of special waste must be in compliance with the regulations in force.
-G
ITTY RITTY
41
or authorized centers.