Comunello Automation CONDOR 220 Mode D'emploi page 18

CONTENTS
1 PRESCRIPTIONS
1.1 SAFETY PRESCRIPTIONS
1.2 INSTALLATION PRESCRIPTIONS
1.3 OPERATING PRESCRIPTIONS
2 PRODUCT DESCRIPTION AND INTENDED USE
2.1 PRODUCT DESCRIPTION
2.2 TYPICAL INSTALLATION
3 TECHNICAL SPECIFICATIONS
4 INSTALLATION
4.1 PRELIMINARY CHECKS
4.2 OPERATING LIMITS
4.3 PREPARATORY WORK FOR INSTALLATION
4.4 INSTALLATION
4.4.1 INSTALLATION
4.4.2 INSTALLATION OF LIMIT STOPS AND SWITCHES
4.4.3 OPERATOR MANUAL RELEASE
5 PREPARATION FOR ELECTRICAL CONNECTIONS
6 TESTING
7 PRODUCT MAINTENANCE
8 SPARE PARTS
9 DISPOSAL
10 WARRANTY
1 PRESCRIPTIONS
1.1 SAFETY PRESCRIPTIONS
This installation manual is addressed exclusively
to professionally skilled personnel. Read all
the instructions carefully before starting the
installation procedures. Any operations that are
not expressly set down in these instructions
are to be considered prohibited; improper
use may result in damage to the product
and place persons and property at risk. The
manufacturer declines all liability for failure to
observe best practices in gate construction
and for any possible deformation that may
occur during use of the product. Store this
manual in a safe place for future reference.
The design and construction of the devices of
which model CONDOR is composed and this
manual are in full compliance with statutory
legislation.In consideration of potential hazards
that may arise during the installation and use
of CONDOR, the installation procedures must
be carried out in full compliance with the
applicable laws, standards and regulations;
namely:
1.2 INSTALLATION PRESCRIPTIONS
• Before starting the installation procedures
make sure you have any additional devices
and materials that may be required to
complete the CONDOR gate opener system
in consideration of the specific application.
• The automation system must not be
used until the gate has been made safe
• Dispose of packaging
compliance with
18
COMUNELLO ®Copyright 2021 - All rights reserved
materials in
local regulations.
1.3 OPERATING PRESCRIPTIONS
• No modifications can be made to any part
of the product unless specified in this
manual. Unauthorized modification of the
product is likely to lead to malfunctions
and risks. The manufacturer declines all
liability for damage caused by unauthorized
modifications.
• The parts of the automation system must
never be immersed in water or other
liquids. During the installation procedures
ensure that no liquids penetrate inside the
control unit or other open devices.
• If liquids penetrate any parts of the gate
opener disconnect the electrical power
supply immediately and consult Comunello
technical service; the use of CONDOR in
such conditions may give rise to potentially
hazardous situations.
• Keep all parts of CONDOR away from heat
sources and open flames; exposure to heat
or flames may damage the devices and
cause faults, fire, or hazardous situations.
• When the equipment remains unused for a
long time, remove the optional battery and
store it in a dry place to avoid the risk of
leakage of harmful substances.
• Connect the control unit exclusively to an
electrical power supply line equipped with
an efficient protective earth conductor.
• Any operations that require the housing
of CONDOR to be opened must be
performed with the control unit and the
electrical power supply disconnected;
if the disconnect device is not clearly
visible, attach a warning notice to the
effect: "WARNING - MAINTENANCE IN
PROGRESS".
• In the case of tripping of circuit breakers or
blowing of fuses, find the fault and remedy
it before resetting the circuit breaker or
changing the fuse.
• If the fault cannot be remedied using the
information given in this manual, consult
COMUNELLO technical service
2 PRODUCT DESCRIPTION AND INTENDED USE
2.1 PRODUCT DESCRIPTION
Electromechanical articulated arm operator designed for use with lightweight
structures and for single leaves up to 2.2 metres and 3.5 metres. Composed
of a compact aluminium housing and die cast alloy arm.