Commissioning, Operation - WIKA CPH62I0 Mode D'emploi

6. Commissioning, operation

6. Commissioning, operation
6.1 Operator panel and basic operation
GB
On turning the device on, if the logger function is selected, the integrated clock's time
will be displayed briefly. If a zero point adjustment has been carried out, the display will
indicate this by showing "nuLL-Corr".
After changing the battery the menu for setting the clock is activated automatically
('CLOC'). Check the clock and adjust if necessary (see chapter "6.3.11 (CLOC) Real
time clock").
1. ON/OFF
2. SET/MENU:
3. TARA:
4. STORE/QUIT: Activate hold function or logger function
5. MIN/MAX:
Max-Function:
Min-Function:
Hold-Function: By pressing ´STORE/QUIT´ the instantaneous measured value will
Logger-Functions: Activated by the ´STORE/QUIT´ key, only if the logger has been
Tare-Function:
18
1
2
Enter configuration menu
Activate tare function, zero point adjustment
(see chapter "6.4 Operation of logger")
Display the respective min-/max-memory value
Pressing ´MAX´ shows the maximum measured value recorded.
Pressing it again hides it. To clear the max-memory press the ´MAX´
key for > 2 seconds.
Pressing ´MIN´ shows the minimum measured value recorded. Press-
ing it again hides it. To clear the min-memory press the ´MIN´ key for >
2 seconds.
be shown in the lower display. Pressing it again hides it. (Only when
logger = 'off' is selected in the main menu).
selected via the main menu (see chapter "6.4 Operation of logger").
By pressing ´TARA´, the display will be set to 0. All measurements
from then on will be displayed relative to the set tare value. When the
tare function is activated, the arrow ´TARA´ appears in the display. To
deactivate the tare function press ´TARA´ for > 2 seconds.
5
5
WIKA operating instructions, model CPH62I0
3
4