Skil 3310 Consignes D'utilisation/De Sécurité page 44

SM 2610008289 10-13_3310 Table Saw 10/14/13 9:46 AM Page 44
8. Loosen the two riving knife attachment screws (Fig 22).
9. With the paper spacing gauge placed between the riving knife
and the rip fence, align and clamp the riving knife with the rip
fence and the spacing gauge (Fig 23). Retighten the riving
knife attachment screws (Fig 22).
10. Return the saw to the upright position, remove the clamp
and paper spacing gauge and recheck the riving knife
alignment. Readjust if necessary.
IMPORTANT: The riving knife must always be INLINE with
the saw blade body when blade is at any bevel angle (see
Fig 13 on page 36).
11. Reinstall the insert plate. Reattach the Anti-Kickback Device
and Guard Assembly to the riving knife.
FIG. 22
44
FIG. 23