Skil 3310 Consignes D'utilisation/De Sécurité page 34

SM 2610008289 10-13_3310 Table Saw 10/14/13 9:46 AM Page 34
9. Remove the combination square and stand the saw in the
adjustment position - on its back side so you can access the
six adjustment nuts 6, 7, 8 (Fig. 12) that secure the pivot rod to
the table. Make sure the table is stable. Place tool on corner of
table and secure with a clamp as shown in figure 12. The front
adjustment screws 6 are accessible from outside of the base.
Handle blade with care and cover blade
W RNING
perimeter during adjustments. Blade teeth are
sharp.
10. Use a 10 mm wrench, or 10 mm socket and 1/4" drive
wrench, where accessible, to loosen adjustment nuts 6 & 7
(about 1/2 turn each).
11. Adjust the blade to 45 degree bevel setting and lock with
bevel lock knob to get access to the remaining two
adjustment nuts 8. Loosen these remaining two adjustment
nuts by approximately ½ turn each – Fig. 14.
12. Adjust the blade back to 0 degree bevel setting and lock
with bevel lock knob.
13. Carefully move the blade to the left or right to align with
miter gage groove. If movement of the undercarriage and
blade is difficult, then loosen the adjustment 6, 7, 8 nuts by
additional ¼ turn.
14. Keep tool in adjustment position. Check the alignment with
the combination square (repeat steps 4 – 7).
15. When alignment is correct, tighten the two front (6) and two
side 7 adjustment nuts.
16. Re-check the alignment. If additional adjustment is required,
loosen the two front 6 and two right 7 adjustment nuts and
repeat steps 13, 14, & 15 until the blade is parallel to the
miter slot.
17. Next, adjust the blade to 45 degree bevel setting to get
access to the remaining two adjustment nuts 8. Tighten
these remaining two adjustment nuts 8.
18. Place the saw upright and re-check the alignment to make
sure the blade is parallel to the miter slot (steps 4 - 7).
FIG. 13
8
FIG. 14
8
34
FIG. 12
6
7