The Gator ® Speedload ™ (Gsl) Cutting System - Oregon ST600 Mode D'emploi

INSERTING AND REMOVING THE
BATTERY PACK (FIG. H)
Only use the Oregon® brand battery packs
specified in these operating instructions
Align the groove in the battery with the rails
inside the battery port Firmly insert the battery
pack into the powerhead's battery port, pressing
forward until it clicks as it locks into place
To remove the battery pack, lift up on the battery
release, grasp the sides of the battery pack and
remove it
OPERATING THE STRING TRIMMER
WARNING: Always hold the string trimmer
away from the body keeping clearance
between the body and the tool. Any contact
with an attachment cutting head can result in
burns and/or other serious personal injury.
If debris becomes wrapped around the
attachment, release the variable speed trigger,
remove the battery pack, and remove the debris
ST600 Multi-attachment
Operation and Maintenance
The Gator
Cutting System
ADVANCING TRIMMER LINE
The GSL disk lasts longer than typical trimmer
lines However, the trimmer line will wear down
over time Advance the line by bumping the head
against the ground to get more line out of the disk
With the motor running and the trimmer head
turning, bump the trimmer head on the ground
More trimmer line comes out of the disk, and
excess trimmer line is cut off by the line cutting
blade on the bottom of the guard
If the trimmer line does not come out, the disk
may be empty Turn off the trimmer/edger and
replace the disk as described in "Replacing the
GSL Disk"
OPENING THE GSL HEAD (FIG. I)
WARNING: A battery operated tool
with the battery pack inserted is always
on and can start accidentally. Remove
the battery pack from the string trimmer
before inspecting, cleaning, or performing
maintenance.
If you detect a problem with the operation of the
GSL Cutting System and need to inspect the disk
or head, follow these steps to open the GSL head:
• Remove the battery, then place the string
trimmer upside down
• Press the GSL head to release the bottom part
of the base
CLOSING THE GSL HEAD (FIG. J)
• Check the disk and clear any blockage or replace
the disk See "Replacing the GSL"
• Remove clippings, dirt, and debris
• Place GSL head back onto the base and press
firmly until it clicks into place
Speedload (GSL)
® ™
15