Troubleshooting - Oregon ST600 Mode D'emploi

Troubleshooting

Use this table to see possible solutions for problems with the string trimmer If these suggestions do not
solve the problem, see "Warranty and Service"
SYMPTOM POSSIBLE CAUSE
Grass wound between
Trimmer/Edger
shaft and trimmer head
does not cut
properly
GSL disk empty
GSL disk empty
Trimmer line
does not feed
Trimmer line tangled
Higher cutting speed than
necessary
Trimmer line wears
out quickly
Improper cutting
technique
GSL head damaged
Trimmer/Edger
GSL head not attached
vibrates excessively
properly
during use
Line cutting blade is dull
End of trimmer line
is frayed, ragged, or Line cutting blade is dull
unevenly cut
18
Troubleshooting
RECOMMENDED ACTIONS
See "Correcting Grass Bind"
See "Replacing the GSL Disk"
See "Replacing the GSL Disk"
Remove the GSL disk See "Replacing the GSL Disk"
Apply less pressure to the variable speed trigger
Avoid forcing the trimmer head against hard surfaces
Slowly move the trimmer head in until the edge of the
trimmer line strikes the grass or weeds
See "The Gator® Speedload™ (GSL) Cutting System"
Remove the GSL head and reinstall, making sure
the nut is securely tightened See "The Gator®
Speedload™ (GSL) Cutting System"
See "Sharpening the Line Cutting Blade"
See "Sharpening the Line Cutting Blade"
ST600 Multi-attachment