Publicité
Les langues disponibles
Les langues disponibles
10.2 Checking the automatic chain lubrication
You should check the operation of the automatic chain lubrication system on a regular basis
in order to guard against overheating and the associated damage to the cutter rail and the
saw chain. To do this, point the tip of the cutter rail towards a smooth surface (board, section
of a cut tree) and allow the chainsaw to run.
If an increasing oil trace becomes evident during this process then the automatic chain
lubrication system is working properly. If no clear oil trace is evident then please refer to the
corresponding instructions in "Troubleshooting". If the information contained there still fails to
remedy the situation then please contact our service department or another similarly qualified
workshop.
Caution: Do not actually touch the surface with the tip of the cutter rail when performing this
test. Keep a safe distance (approx. 20 cm).
10.3 Sharpening the saw chain
Effective working with the chainsaw is only possible if the saw chain is in good condition and
sharp. This also reduces the risk of kickback.
The saw chain can be re-sharpened by any dealer. Do not attempt to sharpen the saw chain
yourself unless you have the necessary special tools and experience.
11. CLEANING AND STORING
• Regularly clean the clamping mechanism by blowing it out with compressed air or cleaning it
with a brush. Do not use tools for cleaning.
• Keep the handles free of grease so that you can maintain a firm grip.
• Clean the device as required with a damp cloth and, if necessary, mild washing up liquid.
• If the chainsaw is not to be used for an extended period of time then you should remove the
chain oil from the tank. Briefly immerse the saw chain and the cutter rail in an oil bath and
then wrap them in oil paper.
Caution:
• Always disconnect the mains plug before cleaning the chainsaw.
• Never immerse the unit in water or other liquids in order to clean it.
• Store the chainsaw in a safe and dry place out of the reach of children.
12. NOTES ON ENVIRONMENTAL PROTECTION / DISPOSAL
The device must be properly disposed of when it reaches the end of its service life.
Cut off the power cable to prevent it being used by mistake. The device must not be disposed
of as domestic waste. Instead, in the interests of the environment it should be disposed of via
a designated recycling or disposal point for electrical equipment. Please contact your local
authorities for information about proper disposal of the device in your area. Packaging
materials and worn accessory parts should also be disposed of at the designated recycling or
disposal points.
13. ORDERING REPLACEMENT PARTS
33
Publicité
