Publicité
Les langues disponibles
Les langues disponibles
• Carefully unpack all parts and check that they are complete (Fig. 1).
• Undo the fixing screw of the chain wheel cover (Fig. 2).
Fig.2
Fig.3
• Take off the chain wheel cover (Fig. 3).
• Lay the chain as shown in the groove which runs around the cutter rail (Fig. 4).
Fig.4
Fig.5
• Insert the cutter rail and chain as shown in the mounting in the chainsaw. At the same time
guide the chain around the chain wheel (Fig.5).
• Attach the chain wheel cover (Fig. 6) and secure it with the fixing screw (Fig. 7).
Fig.6
Fig.7
Caution:
Do not fully tighten the fixing screw until after adjusting the chain tension.
7.2 Tensioning the saw chain
Caution:
Always disconnect the mains plug before performing any checks or adjustments.
Always wear protective gloves when working on the chainsaw to protect yourself against
injury.
• Undo the fixing screw of the chain wheel cover a few turns (Fig. 2).
• Adjust the chain tension with the chain tensioning screw (Fig. 8). Turning the screw
clockwise increases the tension, turning it counterclockwise decreases the chain tension. The
saw chain is correctly tensioned if it can be lifted around 3-4 mm in the middle of the cutter
rail (Fig. 9).
25
Publicité
