Replacement Parts/Accessories; Trouble Shooting - Grizzly Tools ERM 1332 Traduction De La Notice D'utilisation Originale

GB

Replacement parts/Accessories

Spare parts and accessories can be obtained at
If you have any other questions, contact the "Service-Center" (see „Service-Center").

Trouble Shooting

Problem
Equipment does
not start
Motor stops
Result unsatis-
factory or motor
labours
Blade fails to turn
Strange noises, rat-
tling or vibrations
74
www.grizzlytools-service.eu
Possible Cause
Power is off
Defective start lever
( 16) or release button
( 15)
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object Remove the foreign object
Cut height too low
Blade ( 23) blunt
Blade area blocked
Blade ( 23) assembled
incorrectly
Blade ( 23) blocked by
grass
24) loose Tighten the blade screw
Blade screw (
24) loose Tighten the blade screw
Blade screw (
Blade ( 23) damaged
Fault Fixing
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
Repair by customer services
Set a greater cut height. Lift the front
wheels slightly by pressing down on
the handle bar.
Set a higher cut height
Have the blade sharpened or re-
place it
Clean the equipment
Install the blade correctly
Remove the grass
Replace the blade