Assembling - Optika Italy OPTIGEM Serie Manuel D'utilisation

8.

Assembling

1. Remove the base from its packaging and place it on a flat
surface. The base is already assembled from the factory and
does not require any further assembly procedure other than
that of mounting the microscope body.
2. Insert the microscope body in the holder. (Fig. 1)
3. Lock the fixing knob ①. (Fig. 2)
4. Remove the dust caps from the eyepiece sleeves and insert
the eyepieces. (Fig. 3)
5. Connect the jack of the power supply to the socket in the rear
part of the microscope base. (Fig. 4)
Page 11
①
F ig. 1 F ig. 1
F F ig. 2 ig. 2
F ig. 3 F ig. 3
F ig. 4 F ig. 4