Publicité
Les langues disponibles
Les langues disponibles
GB
<< The machine may not be operated by more than one
person at any given time!
The machine was designed for safe operation by "one
person only".
<< During the shredding process no other work may be
performed on the machine (for example cleaning,
etc.)!
<< The machine is not a toy, and is not suitable for use
by children!
The overall technical safety concept of this machine
(dimensions, feed openings, emergency shutdown de-
vices etc.) does not provide for any guarantee regarding
hazard-free operation by children.
APPLICATION:
The intimus H200CP4 (852CC) shredder is used in
all areas where large quantities of printed material
need to be shredded.
The machine can shred cardboard and crumpled
paper as easily as it shreds smooth paper.
The shredder should mainly be fed with
paper or cardboard!
Other materials according to the data sheet:
Only shred in small amounts and not per-
manently.
Shredding other data carriers can cause
injury(e.g. by splintering of hard materials) or
may damage the shredder (e.g. destruction of
the cutting system).
I
MAINS SWITCH
fig. 1
IMPORTANT SAFETY PRECAUTIONS
INITIAL START UP
INSTALLATION REQUIREMENTS:
Note: Be certain that three phase current is available
at the point of installation (see TECHNICAL DATA for
information concerning required pre-fusing of the
electrical outlet).
- Unpack and set machine upright.
- Put the collecting bag into the sliding frame (see
description „EMPTYING THE COLLECTING BAG")
- Plug in the machine.
The air vents in the housing are necessary
for cooling and may not be covered or
closed!
The mains connection at the machine must
be freely accessible!
Only operate the machine in enclosed
rooms at temperatures between 10°C
and 25°C!
POWER SUPPLY CONNECTION:
a) The maximum value for loop impedance at the
mains connection point is 0.5 Ohms.
b) The conductor cross-section of the power supply
line should be of a magnitude so as to cause a 15%
voltage drop in the case of a machine blockage
(inhibit current = 6 x nominal current).
1
<< Danger of injury! Keep all loose articles of
clothing, ties, jewelery, long hair or other
loose objects away from opening!
<< Danger of injury! Never insert fingers into opening!
<< In case of danger switch the machine off with the mains
switch, or with the emergency switch, or unplug the
machine!
<< Always unplug the machine from the mains power
supply before opening the machine!
Repairs may only be performed by trained personnel!
CHECKING THE RUNNING DIRECTION:
1. Move the main switch (1) (fig. 1) to position „1".
2. Press the „forward" button (2) (fig. 2). The cutting
3. Check that the cutting system is running in the
Now that everything has been correctly assembled
and connected, you can proceed to operating the
machine.
5
H200CP4 (852CC)
system starts running.
correct direction and correct the phase relation
of the power plug if necessary.
Correcting the phase relation of the
power plug may only be carried out by
a qualified electrician!
S
4
3
2
5
fig. 2
6
7
Publicité
