Connection And Installation - Sygonix 1911206 Notice D'emploi

6. Connection and installation

To ensure that the device is configured correctly,
read these instructions and the safety information
carefully before first use. In case of doubt, have the
installation and connection performed by a special-
ist.
The connection may only be performed in a de-
energised/currentless state. Otherwise there is a
risk of a fatal electrical shock!
The power consumption of the connected loads
must not exceed the rated power of the built-in
switch. The minimum connection values must be
strictly observed. Please observe chapter "13.
Technical Data".
The construction of the product corresponds to
protection-class II (double or reinforced insulation).
The product may therefore only be used for devices
(e.g. lighting fixtures) with protection class II.
The product is only suitable for devices operating
from the mains voltage.
36