Setup Menu; General Information; Opening The Setup Menu - nissen 12/24 V-35A Instructions De Service

Setup menu

General informa- -
tion -
-
Opening the Set-
up menu
1
2
10 s
-
The Setup menu is used for selecting a suitable synergic line for the battery
Each synergic line is identified by a set number of flashing LEDs on the control panel
The different LED combinations for identifying a synergic line can be found in the "Syn-
ergic lines" chapter
NOTE! Charger leads must not be connected to the battery before or during the
setting process in the Setup menu. If charger leads are connected, no settings
can be made.
Connect mains cable to charger and plug into mains
- Charger in open circuit - both ready indicators light up
Press the Stop/Start button and hold it down for approx. 10 s
- Setup menu is called up
- Both ready indicators go out
- The charger is in Setup mode
The set synergic line is shown on the display, e.g.: Synergic line 1
43