Installation; Safety - nissen 12/24 V-35A Instructions De Service

Installation

Safety

Installation If installing the charger on a firm base, use the drilling template supplied.
Observe the following space requirement measurements to ensure easy access to the plug
connections. Dimensions in mm (in.):
* Space for fitting/removal
38
WARNING! Work that is carried out incorrectly can cause serious injury and dam-
age. The charger must only be installed by trained and qualified personnel. Pay
particular attention to the "Safety rules" chapter in all operating instructions, in-
cluding these instructions, for system components.
NOTE! IP 40 degree of protection is guaranteed for the upright position. If the
charger is installed in a switch cabinet (or a similar separate area), then forced-
air ventilation must be provided to ensure adequate heat dissipation. There must
be a clearance of 10 cm (3.94 in.) all around the charger.
6,5
(.26)
247 (9.72)
233 (9.17)
88 (3.46)