Accessories; Remote Control; Zone Modes - Smanos L020 Manuel D'utilisation

EN

Accessories

Remote Control

Overview
LED Indicator
Arm
Disarm
Stay
SOS
Note: If you press any button, the LED indicator is dusky and lights off after
Button System Status
Press once to arm the system. The siren beeps once and the
Press once to disarm the system. The siren beeps twice and the
Note: System will alarm immediately if 24-hour zone detector
or tamper switch of sensor is triggered.
Press once to home arm the system, the siren beeps once after
system is in home mode.
Note: System stops handling signal from home mode zone
detector, which enable users to move freely at home.
Guide Point For The Blind

Zone modes

There are three zone modes available for the sensors.
Metal Ring Normal zone:
normal zone work normally. Once intrusion is detected, the
detectors trigger an alarm.
Home mode zone:
detectors set to home mode zone are disarmed. The detectors set
to other zones are armed. That is, partial arm.
24-H zone:
immediately when detecting intrusion, no matter the system is
armed or disarmed.
Note:
will receive an emergency message from App.
Press the [stay ] button, the indicator on the remote control
blinks once, and then press [Arm ] button within 3 seconds
to mutely arm the system.
Press the [stay ] button, the indicator on the remote
control blinks once, and then press [Disarm ]
3 seconds to mutely disarm the system.
In arm or home arm state, the detectors set to
When system is in home arm state, the
The detector set to 24-H zone trigger an alarm
Sensors in This Kit Zone Mode (Default Setting)
Normal Zone (can be changed through
DS2300 Door/Window Contact
App)
The zone mode of 24-hour zone sensor can not be changed.
EN
button within