WMF LONO Instructions D'emploi page 34

Fault Remedy
The quality of the ▪ On a new unit, the optimal quality of the crema is only realised if the
crema insufficient.
▪ Clean and descale the strainer at regular intervals.
▪ The sieves in the in the sieve unit may not be pressed against each other.
The spout drips for a ▪ After brewing, always move the adjusting knob back to the home posi-
long time.
The device switches off ▪ Do not operate the appliance at altitudes higher than 1500m above sea
during heating.
The rinse procedure ▪ It is important to press both buttons at the same time.
does not start.
The descaling pro- ▪ It is important to press both buttons at the same time. Try it again and
gramme does not start.
Water is escaping from ▪ Check to see whether the pad has been correctly inserted into the pad
the handle on the pad
cartridge
▪ Sudden water leakage can also occur in the event of a clogged pad
There is water under ▪ Empty the drip tray in good time.
▪ At the highest, fill the water tank to its max mark.
the device.
▪ Never allow the appliance to stand for a long time without a water
34
appliance is in use for some time.
If this does happen, then it needs to be replaced.
tion (C). This will prevent a long dripping.
level.
first release the button once the scaling indicator remains illuminated
and the pump is running.
cartridge. If the paper edge of the pad extends beyond the edge of the
recess, the seal will be prevented during brewing.
cartridge.
tank.