Installation; Mount Controller - Rain Bird ESP-Me Manuel D'utilisation

Installation

Mount Controller

A
Drive a mounting screw into the wall, leaving an
1/8 inch gap between the screw head and the
wall surface (use the supplied wall anchors if
necessary), as shown.
B
Locate the keyhole slot on back of the controller
unit and hang it securely on the mounting screw.
A
1/8 IN.
C
B
Open the front panel, and drive three additional
screws through the open holes inside the
controller and into the wall, as shown.
C
VT MV COM 5 6 7 11 12 13 17 18 19
1 2 3 4 8 9 10 14 15 16 20 21 22
VT MV COM
1 2 3 4
VT = VALVE TEST
CONNECT
120 VAC
ESP-Me Controller
ENG
7