Tb5 Program Connections - FloTech FT204P Mode D'emploi

FloTech Programmable Retain / Overfill Monitor
TB5 RESET Connections
Refer to Fig. 7 . The Reset/Timer terminals connect to a
Normally Open push button switch. The primary function of
this switch is to override wet Retain Sensors for „Splash
Blending‟ product. When this button is pressed, the FT203P
Monitor will issue a Permit signal to the Rack without regard to
the Retain Sensors for up to 90 minutes. The Permit signal will
be disabled if any of the Overfill Sensors become wet or there is
signal activity on any Retain Sensors that have been
programmed as inactive.
Fig. 7
Timer/Reset and Program Connections

TB5 PROGRAM Connections

Refer to Fig. 7. The FT203P Monitor must have a jumper
installed in the PGM terminals ONLY during programming of
the monitor. This connection must be left open for normal
operation. See the Programming Section of this manual for
detailed instructions about programming this unit.
14 10464 REV C