Table des Matières
Publicité
3) Set the center hook of the installation plate 2 on the center dented part of the spacer. (Fig. 5)
en
4) Fix the installation plate with screws 3 at 3 points. (Fig. 6)
The 2 points indicated with the white arrows
together in the step 11).
When board anchors are used, drive them at these 2 points as well.
5) Remove the COVER_F, and then the Air Purifying Device. (Fig. 7)
EN-9
Fig. 5
are used to fix the installation plate and the Plasma Quad Connect
Fig. 6
Air Purifying Device
COVER_F
Fig. 7
Publicité
Chapitres
Table des Matières
