Mitsubishi Electric MAC-100FT-E Notice D'utilisation Et Manuel D'installation page 15

10) Attach the 2 hooks at the back side of the Plasma Quad Connect 1 to the installation plate 2. (Fig. 12)
11) Fix the Plasma Quad Connect 1 to the wall with 2 screws 3. (Fig. 12)
12) Attach the Air Purifying Device, then the COVER_F.
13) Run the cable connected to CN105 and the power supply cord to rear side of the indoor unit. (Fig. 13)
power supply cord connecting cable
Run the connecting cable and power supply cord in the space on the back of the unit as shown in the above figure.
Tuck cabling away and secure it.
Note: M ake sure that the connecting cable and power supply cord will not get caught on or between the installation plate
and the wall, and it will not touch the edge of the installation plate.
Failure to do so may cause damage to the connecting cable resulting in communication problems.
14) Make sure that the Plasma Quad Connect 1 can be pulled towards the front side of the indoor unit.
5. Specifications
Input Voltage
Frequency
Power consumption
Size H×W×D
Weight
Fig. 12
Fig. 13
Single Phase AC220 ~ 240V
50/60 Hz
4 W
56 × 499.5 × 168 mm
1600 g
en
EN-12