Mitsubishi Electric MAC-100FT-E Notice D'utilisation Et Manuel D'installation page 8

2. Product Introduction
(1) Product Introduction
• Dirty filters cause condensation in the air conditioner which will contribute to the growth of
fungi such as mold. It is therefore recommended to clean air filters every 2 weeks.
(The Plasma Quad Connect does not function for safety for a couple minutes after the opera-
tion starts or the cover is opened/closed.)
• Do not disassemble the Plasma Quad Connect.
en
• Do not touch any parts other than the frame of the Plasma Quad Connect.
(2) Plasma Quad Connect operation
1 In the AIR PURIFYING operation, Plasma Quad Connect reduces airborne mold, viruses and allergens.
2 Refer to the operation manual of the indoor unit for the remote controller.
3 Press to start AIR PURIFYING operation in conjunction with the indoor unit.
4 Press again to cancel AIR PURIFYING operation in conjunction with the indoor unit.
Note:
• Never touch the Plasma Quad Connect during operation. Although the Plasma Quad Connect is safety-conscious de-
sign, touching this device could be the cause of trouble as this device discharge high voltage electricity.
• A "hissing" sound may be heard during the Plasma Quad Connect operation. This sound is produced when plasma is
being discharged. This is not a malfunction.
• It may take up to 3 minutes before the Plasma Quad Connect starts up after pressing
(3) Cleaning
Instructions:
• Switch off the power supply or turn off the breaker before
cleaning.
• Be careful not to touch the metal parts with your hands.
• Do not use benzine, thinner, polishing powder, or insecti-
cide.
Air filter
Clean every 2 weeks
•
• Remove dirt by a vacuum cleaner, or rinse with water.
• After washing with water, dry it well in shade.
EN-5
Important
• Use only diluted neutral detergents.
• Do not use water hotter than 50°C.
• Do not expose parts to direct sunlight, heat, or fire to dry.
.
Air filter