Dispensing Hot Water; Programming The Hot Water; Dispensing With The Automatic Steam Wand; Tips Regarding Its Use - Storm SAEP Manuel D'utilisation Et D'entretien

6.7 Dispensing hot water

6.7.1 Dispensing hot water
Danger of scalding. Do not di-
rect hot water towards hands or
other parts of the body. Do not
touch the hot water nozzle with bare
hands; use the appropriate PPE.
• Place the pot under the hot water
spout.
• Select the button on the dis-
play.
• Wait for the water to finish dispensing.
• To stop the water dispensing ahead of
time, press the button again.
6.7.2

Programming the hot water

To program the hot water doses, proceed as follows:
• Select the button;
• Press the menu button
• Select the configuration button
• Press the dose programme button
• Select the hot water dose button
• Press the button to start dispensing;
Start
• To confirm and stop the dose, press the
• To check the dose, press the "Test the dose" button
• To delete the dose settings, press the
• The dose can be manually adjusted via the
buttons.
PROGRAMME DOSES
PRE-INFUSION
TIME
0.0"
DETAILED
ADJUSTMENT
Manual dose
adjustment (ml)
48 216
of
;
;
Programme doses
;
button;
Stop
button;
Check the
programmed dose
Start/end of the simu-
lated programming
dose dispensing phase
PROGRAMME
Start
DOSE
Stop
Start
TEST DOSE
Stop
DOSE RESET
Delete dose
configuration
6.8 Dispensing with the automatic
steam wand
6.8.1

Tips regarding its use

• Only froth the amount of milk that you intend to use; once
heated, the milk will have to be completely poured out of
the jug and cannot be reheated.
• The automatic steam wand only guarantees an accuracy
of ± 3°C between the set temperature and the actual milk
temperature, if the starting milk temperature is 4°C.
• As the steam automatically stops dispensing when the set
milk temperature is reached, only fill the jug half way in
order to prevent the milk froth from spilling out.
• Use a suitably-sized jug for the amount of milk that re-
quires frothing (approx. 200 ml is recommended) and
make sure that it is circular and not conical (see the im-
age).

Dispensing

6.8.2
Do not direct the steam towards hands or other
parts of the body. Do not touch the steam nozzles
with bare hands; use the appropriate PPE.
Before using steam to heat and froth the milk, a
dry dispensing run must be completed by pressing
one of the selection buttons to let out several short
;
spurts of air, until all the condensation water has been re-
leased. To stop dispensing, press the same button again.
• Immerse the automatic steam wand nozzle tips into the
milk.
;
Start
and
Medium auto- Continuous
matic steam
wand dose
Small auto- Large auto-
matic steam matic steam
wand dose wand dose
frothing
USER Manual