Lighting; Automatic Coffee Dispensing Function; Preparing The Filter Holder - Storm SAEP Manuel D'utilisation Et D'entretien

6.4.2

Lighting

Work surface
To turn the work surface light on and off, press the
Logo backlight
To turn the Logo backlight on and off, press the
The light intensity calibration bar (on the work sur-
face or the logo backlight) is activated by pressing
and holding the buttons.

6.5 Automatic coffee dispensing function

Preparing the filter holder

6.5.1
Before filling the filter holder, make sure it is emp-
ty and any previous coffee residue has been re-
moved.
• Fill the filter with a dose of ground coffee (approx. 6-7 g);
follow the procedures specified by the manufacturer of
the grinder-dispenser.
• Compress the coffee with the special press.
• Clean the rim of the ground coffee filter before attaching
the filter holder to the dispensing group.
• Hook the filter holder to the group without closing it too
tightly in order to prevent the gasket from wearing quickly.
46 216
of
6.5.2
button.
• Place the cup under the dispens-
ing spout.
Work surface
light
• Press the desired dose button, e.g.
button.
dispensed (LED will light up).
Logo
• To stop coffee dispensing ahead
backlight
of time, press the
again.
Light
adjustment
bar
In the case of two or more concurrent dispenses, the graph
on the other displays will not indicate the real pre-infusion
pressure value, but the instantaneous pressure value, since
the pump is already in operation.
• In order to continuously dispense coffee, select the
button and stop it by pressing the same
again.
Automatic coffee dispensing function
Do not remove the filter holder from the dispens-
ing group when coffee is being dispensed.
and wait until the coffee is
button
Hot water dispensing
enabled
The graph only indicates the exact pre-infusion
pressure trend when a single dispense is in prog-
ress.
Dispensing time
Temperature
Dispensing pressure
Steam pressure
Red chart:
dispensing pressure
Blue chart:
dispensing quantity
button
USER Manual