Alecto WS5400 Mode D'emploi page 37

Step Mode
10 Temperature unit
11 Wind speed unit
12 Baro unit
13 Rain unit
14 Light intensity unit
15 Channel auto loop
16 7-in-1 sensor point to
Console will exit setting mode automatically, if no operation after 60 seconds.
SETTING ALARM TIME
1. In normal time mode, press and hold [ ALARM ] key for 2 seconds until the alarm hour digit flashes to enter alarm time
setting mode.
2. Press [ WIND / + ] or [ NDX / - ] key to change the value. Press and hold the key for quick-adjust.
3. Press [ ALARM ] key again to step the setting value to Minute with the Minute digit flashing.
4. Press [ WIND / + ] or [ NDX / - ] key to adjust the value of the flashing digit.
5. Press [ ALARM ] key to save and exit the setting.
6. When enabled the icon will be visible on the LCD.
ACTIVATING THE ALARM FUNCTION
1. In normal mode, press [ ALARM ] key to show the alarm time for 5 seconds.
2. When the alarm time displays, press [ ALARM ] key again to activate the alarm
function.
When clock reaches the alarm time, the alarm function will be trigered.
The alarm can be stopped by either of the following 4 operations
1. After 2 minutes of alarm the alarm will stop automatically while staying activated for the next day.
2. By pressing [SNOOZE / CONTRAST] key to enter snooze mode that will postpone the alarm by 5 minutes.
3. By holding [SNOOZE / CONTRAST] key for 2 seconds to stop the alarm and will activate again in the next day
4. By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next day.
TEMPERATURE & HUMIDITY
The temperature and humidity reading are display on the outdoor and indoor / CH section.
If the reading is below the measurement range, it will show "LO". If reading is above the measurement range,
it will show "HI".
Press [ WIND / + ] or [ NDX / - ] key to change the rain display unit between
˚C or ˚F
Press [ WIND / + ] or [ NDX / - ] key to change the unit in sequence: m/s
km/h knots mph
Press [ WIND / + ] or [ NDX / - ] key to change the unit in sequence: hPa
inHg mmHg
Press [ WIND / + ] or [ NDX / - ] key to change the rain display unit between
mm or in
Press [ WIND / + ] or [ NDX / - ] key to change the Light intensity unit in
sequence: Klux Kfc
Press [ WIND / + ] or [ NDX / - ] key to enable or disable channel auto loop
function
Press [ WIND / + ] or [ NDX / - ] key to select the sensor located hemisphere
(e.g. US and EU countries are also "N", Australia is "S")
Setting procedure
W/m².
Alarm off Alarm on
37