Introduction
Packing contents
• 1 remote control DCIR (without batteries)
• 1 remote control base with infrared receiver
• 1 telephone cable 6/6 right - right - Length about 150 cm.
• 2 RJ jack boxes
• 1 instruction manual
After the delivery, check that the packing is not damaged and shows no evident signs of falls or abrasion.
Should this be so, contact immediately the supplier. Check that the contents correspond to the above-
mentioned list of materials.
Contents of this Instruction Manual
This manual describes the DCIR control remote control, together with its specific procedures of installation,
configuration and use.
Read carefully this manual, in particular the chapter concerning the safety rules, before the remote control
installation and use.
Addressee of the Instruction Manual
The different parts of this manual are meant to satisfy two operative requirements, those of the installer
technician and those of the operator.
Installer technician: skilled technician able to carry out the safety system installation and to verify its
functionality.
He has the necessary technical knowledge to install, connect and configure the system. Only the installer
technician is allowed to carry out the operations reserved to "Technical staff".
Operator: end user who operates on the control remote control to set up the operating modes of the whole
system. In case of multi-user systems, up to 4 operators can work at the same time on the available resources
(video inputs, monitors, etc.).
What to read
The installation procedures, mainly addressed to the installer technician are described from page 4.
The operator is supposed to read from page 10, for the use of the remote control and switching functions.
Typographic conventions
Different graphic symbols are used in this manual, the meaning of which is here described:
Hazard of electric shock; disconnect the power supply before proceeding, if not otherwise specified.
Read carefully the procedures or information indicated, and if necessary carry out what is prescribed
according to the required modalities. An incorrect procedure may compromise the system operation or damage
it.
Read carefully to understand the system operation.
Pag. 2
DCIR_4402