mysoda RUBY Mode D'emploi page 4

INSTALLING THE CO2 CYLINDER
1
1
2
1. Remove the water bottle by pulling the 2. Uninstall the top part of
bottle and carbonation nozzle towards the device body by turning it
yourself, and then unscrew it (one anti-clockwise.
quarter clockwise).
4. Remove the seal and cap from the 5. Install the CO2 cylinder by
CO2 cylinder. screwing it clockwise. Attach the
cylinder firmly enough, but do not
tighten too much.
CHANGING THE CO2 CYLINDER
After the CO2 cylinder is empty, replace the CO2 cylinder in the same way as the first time you installed the
cylinder.
Usage tip: A used CO2 cylinder can be refilled by your Mysoda dealer. Return the empty
cylinder so that you only pay for the gas refill.
Usage tip: Buy another CO2 cylinder in your home so that you can replace it as soon as
you run out of gas. Extra cylinders are available from Mysoda dealers.
6
2
3. Unscrew the black thread
protective cap on the top part of the
device body.
2
1
6. Carefully insert the CO2 cylinder
and top part together to the bottom
part. Turn the top part clockwise until
it clicks into place.
HOW TO MAKE SPARKLING WATER
1. Fill the water bottle with cold water up to the
fill line.
3. Push the carbonation button 2–3 times,
stop when you hear a hissing sound.
5. Release the bottle by turning it by one
quarter clockwise.
NOTE: Only use compatible CO2 cylinders and Mysoda water bottles. Never carbonate if
the bottle is empty, not fully inserted with water or if water is above the fill line.
1
2
2. To insert the water bottle, make sure that the device
is in a fully upright position and the bottle quick-lock is
angled forward. Then insert the bottle in quick-lock and
turn one quarter anti-clockwise to lock. Push the bottle
towards the device to a vertical position.
4. Pull the bottle towards yourself to release pressure
inside the bottle.
6. Enjoy your carbonated water or add desired
flavour.
EN
7