Christopeit Sport RS 100 Notice De Montage Et D'utilisation page 14

Step 3:
Attach the computer holder (5) and Computer (37).
1. Place the computer holder (5) against the main frame (1) and connect
the plug for the computer cable (22) with the matching plug for the
sensor cable (21).
2. Put the computer holder (5) onto the locator provided for it at the main
frame (1). Ensure that the cable connection made are not squashed.
Screw the computer holder (5) at main frame (1) in straight direction
with screws M8x16 (14), spring washers (16) and arc washers 8//25
(19).
3. Take the computer (37) that has been supplied out of the packaging
and insert the batteries (Type "AAA"-1.5 V pencells) by watching for
the right polarity on the back of the computer (37). (Batteries for the
computer are not included in this item. Please buy them at your located
market.)
4. Put the plug of connection cable (22) into the cable socket from
monitor (37)
5. Attach the monitor (37) to computer holder (5) and tighten with screws
M5x12 (38).
(Attention: Ensure that the cable loom were not crunch or pinch during
installation.)
The screws for computer you find at computers backside.
Step 4:
Attach the seat support (2) and handrail (3) at seat frame (4).
1. Place the seat support (2) onto the seat frame (4) and screw it with
u-shape bracket (8), washer 10//20 (17) and hand grip screw (20).
2. Place the handrail (3) near to the seat support (2) adjust the holes in the
tubes so that they aligned
3. Push the bolts M8x70 (29) through the holes and tighten the handrail
(3) at seat support (2) with washers 8//16 (15) and nylon nuts (30) firmly.
Step 5:
Attach the seat (35) and back cushion (36) at seat support (2).
1. Place the seat (35) with backside onto the seat support (2) so that the
holes are align.
2. Put on each screw M6x15 (31) one washer 6/12 (33) and tighten the
seat (35) at seat support (2) firmly.
3. Place the backside of back cushion (36) against den seat support (2)
so that the holes align.
4. Screw the back cushion (36) at seat holder (2) tightly by using screws
M6x40 (34) and washers 6//12 (33).
14