Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
Remove all the separate parts from the packaging, lay them on the
floor and check that all are there on the basis of the step drawings
in these instructions for assembly and use. Please note that a
number of parts have been connected directly to the main frame and
preassembled. In addition, there are several other individual parts that
have been attached to separate units. This will make it easier and
quicker for you to assemble the equipment. Assembly time: 30 - 40
min.
Step 1:
Attach the stabilizer (6+7) and seat frame (4) at main frame (1).
1. Push the seat frame (4) into the locator provided for it at the main frame
(1). Screw the seat frame (4) at the main frame (1) with screws M8x16
(14), washers 8//16 (15) and spring washers (16).
2. Attach the front foot (6) with the preassembled transport rollers (25) to
the main frame (1). Do this with the two screws M10x65 (10), washers
10//20 (17) and spring washers (13).
Step 2:
Attach the pedals (27L+27R) at pedal crank (28).
1. Screw the right pedal (27R) into the locator on the right-hand side
(as seen in exercise position) for the pedal crank (28) (Warning! The
screw direction is clockwise).
2. Screw the left pedal (27L) into the locator on the left-hand side (as
seen in exercise position) for the pedal crank (28) (Warning! The
screw direction is anti-clockwise).
3.
Then mount the pedal straps left and right (62L+62R) on the associated
pedals (27L+27R). (The pedals are marked with sign "L" for Left and
"R" for Right.)
3. Attach the rear foot (7) with preassembled end caps (26) to the seat
frame (4). Do this with the two carriage bolts M10x65 (9), washers
10//25 (12), spring washers (13) and cap nuts (11).
The equipment should be set up that the equipment does not move of
its own accord during a training session. If you like to change the
position of the recumbent bike, lift up at rear foot (7) until you can
move easy on the front transportation rollers to another place.
13
Publicité
