shark Steam & Spray SS460 Série Manuel Du Propriétaire page 16

fig. 9
HARD FLOOR MOPPING
WARNING: Do not use on unsealed wood or unglazed
ceramic floors. Do not use on wood or tile floors that
are highly worn, unfinished or have a wax or oil finish.
It is always recommended to test an isolated area to be
cleaned before proceeding. You should always check the
use and care instructions from the floor manufacturer.
IMPORTANT: When cleaning with the spray head, make
sure that either the disposable or the washable cleaning
pad is attached to the bottom of the spray head.
IMPORTANT: Always make sure the floors are swept or
vacuumed before cleaning.
1 Connect the body of the unit with the spray head.
(fig. 9)
16 1-800-798-7398
fig. 10 fig. 11
2 Insert the Steam Energized Hard Floor cleanser into
the unit. (fig. 9)
3
Attach the cleaning pad onto the bottom of the spray
head. (fig. 9)
4 Press the Spray Button to apply solution to the floor
that is to be cleaned. Repeat until the entire floor is
cleaned. No rinsing is required. (fig. 10)
5
Once finished, step on the pad and lift the unit to
remove the pad. (fig. 11)
IMPORTANT: Never leave the spray head with a damp
pad on any floor surface for any amount of time as this
may damage the floor.