shark Steam & Spray SS460 Série Manuel Du Propriétaire page 14

fig. 5
STEAM & SPRAY CLEANING
WARNING: Do not use on unsealed wood or unglazed
ceramic floors. Do not use on wood or tile floors that
are highly worn, unfinished or have a wax or oil finish.
It is always recommended to test an isolated area to be
cleaned before proceeding. You should always check the
use and care instructions from the floor manufacturer.
IMPORTANT: When cleaning with the steam head, make
sure that either the disposable or the washable cleaning
pad is attached to the bottom of the steam head.
IMPORTANT: Always make sure the floors are swept or
vacuumed before steam cleaning.
1 Connect the body of the unit with the steam head.
(fig. 5)
2
Open the filling hole on the steam head and fill with
water. (fig. 5)
3
Insert the Steam Energized Hard Floor cleanser into
the unit. (fig. 5)
14 1-800-798-7398
fig. 6
4 Plug into an electrical outlet.
5
Attach the cleaning pad onto the bottom of the steam
head. (fig. 5)
6
Lightly step on the back of the steam head to release the
handle to start automatic electronic steaming. (fig. 6)
7 Press the Spray Button to apply cleaning solution to
sticky stuck on messes as needed. Repeat until the
entire floor is cleaned. No rinsing is required. (fig. 6)
8
Once finished, step on the pad and lift the unit to
remove the pad. (fig. 7)
9
Unplug the steam head from the electrical outlet and
press the head release button to remove from the
main body of the unit. (fig. 8)
IMPORTANT: Never leave the steam head with a damp
pad on any floor surface for any amount of time as this
may damage the floor.
fig. 7
MOP HEAD
RELEASE
fig. 8