Standard Installation - Wolf ICBCI365TFS Guide D'installation

Induction and electric cooktops

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

SPECIFICATIONS

Electrical

Installation must comply with all applicable electrical codes

and be properly grounded (earthed).

Locate the electrical supply as shown in the illustrations on

pages 3–4. A separate circuit, servicing only this appliance

is required. A ground fault circuit interrupter (GFCI) is not

recommended and may cause interruption of operation.

Performance may be compromised if the electrical supply is

less than 220 volts.

When multiple cooktops are installed side by side, each unit

must have its own separate recommended electrical circuit.

REQUIRED POWER SUPPLY

INDUCTION / ELECTRIC

Single phase

220-240V AC, 50/60 Hz

3phase

380-415V AC, 50 Hz

MAXIMUM CONNECTED LOAD

INDUCTION COOKTOPS

SINGLE PHASE

381 mm

3.7 kW

610 mm

6.85 kW

762 mm

7.4 kW

914 mm

11.1 kW

ELECTRIC COOKTOPS

SINGLE PHASE

381 mm

2.9– 3.4 kW

762 mm

6.2– 7.5 kW

3.3 – 3.9 kW

914 mm

8.9 –10.5 kW

3.4– 4.0 kW

Refer to the wiring diagram showing the connections for

each lead to the terminal box on the unit.

WARNING

The complete appliance must be properly grounded at

all times when electrical power is applied.

Do not ground appliance with the neutral (white) house

supply wire. A separate ground wire must be utilized.

If aluminum house supply wiring is utilized, splice the

appliance copper wire to the aluminum house wiring

using special connectors design and agency certified

for joining copper and aluminum. Follow the connector

manufacturer's recommended procedure carefully.

Improper connection can result in a fire hazard.

IMPORTANT NOTE:

Connection of this appliance should be

through a fused connection unit or a suitable isolator, which

complies with national and local safety regulations. The

3PHASE

on/off switch should be easily accessible after the appli-

3.7 kW

ance has been installed. If the switch is not accessible after

3.7 kW

installation (depending on country) an additional means of

3.7 kW

disconnection must be provided for all poles of the power

3.7 kW

supply. When switched off there must be an all pole contact

3PHASE

gap of 3 mm in the isolator switch. This 3 mm contact dis-

connect gap must apply to any isolator switch, fuses and/or

relays according to EN60335.

Single phase wiring diagram.

3phase wiring diagram.

381 mm Cooktop