Allen-Bradley 6189V-OB36 Instructions D'installation page 5

3. Connect the ribbon cable to the mating 40-pin connector that is on the
printed circuit board of the Digital Output Accessory. The connector is
keyed for proper alignment. Make sure the connector is firmly seated.
Digital Output Board and Cover
4. Carefully fold the ribbon cable back into the chassis of the 1200W. Secure
the cable with the retaining clips from which it was removed. Be careful not
to pinch the cable as the Digital Output Accessory is placed into the opening
at the rear of the chassis. Secure the Digital Output Accessory to the chassis
with the screws that were removed in Step 1.
Ribbon Cable removed
from inside of unit.
Digital Output Accessory
Digital Output Accessory
Publication 6180W-IN003B-MU-P
5