arilex G2S65 Instructions Pour L'installation page 96

7.
REPLACING COMPONENTS
7.5 BURNER REPLACEMENT
Stove: Remove the burner (e.g. Fig. 4/A) / Extract the burner body/ Position the new burner
Gas oven: Remove, in sequence, the grills, tray holders and oven base
•
Loosen the retaining screws
•
Pull out the spark plug and thermocouple
•
Remove the burner
•
Position the new burner and tighten the retaining screw again
Check the gas seal with the appropriate instruments and replace the parts removed in the correct order
7.6 HEATER REPLACEMENT
•
Remove, in sequence, the grills, tray holders and oven base
•
Loosen the retaining screws (e.g. Fig. 6/A) and disconnect the
electrical connections
•
Dismantle the heater
•
Fit the new heater and restore the connections
7.7 GAS THERMOSTAT REPLACEMENT
•
Remove the bulb from the support (e.g. Fig. 7/A)
•
Unscrew the gas inlet and outlet connections (e.g. Fig. 7/B)
•
Unscrew the thermocouple
•
Install the new THERMOSTAT
•
Check the minimum screw (see section 6.4 e Technical Data
Tables)
7.8 ELECRICAL THERMOSTAT
REPLACEMENT
•
Remove the bulb from the support (e.g. Fig. 8/A)
•
Install the new THERMOSTAT and secure it to the switch
•
Insert the new bulb into the support
7.9 BULB REPLACEMENT
•
Disconnect the electrical connections
•
Fit the new bulb (e.g. Fig. 8/D)
•
Reconnect the cables
If necessary, check the gas seal with the appropriate
instruments and replace the parts removed in the correct
order
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
B
- 22 - 22
Fig. x
Fig. 6
A
B
Fig. 7
A
D
Fig. 8
C