arilex G2S65 Instructions Pour L'installation page 85

3.
POSITIONING AND HANDLING
3.5 REMOVAL OF PROTECTIVE MATERIALS
The appliance is protected on the exterior surfaces with a covering of adhesive film which must be removed
manually after positioning of the appliance.
Carefully clean the appliance, externally and internally, manually removing all the material used to protect the
parts.
Be careful not to damage stainless steel surfaces. No not use corrosive products, abrasive mate-
rial or sharp tools.
Do not use pressurised direct water or steam cleaners jets for cleaning operations
Do not use harsh materials such as solvents to clean the appliance.
Carefully read the indications contained on the labels of the products used. Wear protective equip-
ment suitable for the operations to be performed (see the protection information shown on the
package label).
Rinse the surfaces with tap water and dry them with an absorbent cloth or other non-abrasive
material.
3.6 LEVELLING AND SECURING
Position in the work place (see operation and environ-
mental limit conditions permitted), previously made
suitable, of the appliance.
The tasks of levelling and securing include: adjustment
of the appliance as a single independent
Place a spirit level on the structure (detail D).
Adjust the levelling feet (detail E) according to the indi-
cations provided by the level.
Perfect levelling is achieved by adjusting
level and feet on the width and depth of the
appliance.
FIXING TOP MACHINES ON STAND
Before proceeding with the operations, see "Handling safety".
Unscrew the front feet of the top appliance (detail A).
Fit the back feet into the corners of the cupboard support (detail B).
Position the appliance so that it fully rests on the cupboard base.
Screw the front feet into the holes provided for fixing to the base (de-
tail A).
Ensure that it is level and assemble in "series".
THIS MANUAL IS THE PROPERT Y OF THE MANUFACTURER AND ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
unit.
- 11 - 11
D
E
B
A
E