arilex G2S65 Instructions Pour L'installation page 81

2.
GENERAL AND SAFETY INFORMATION
2.1 DUTIES AND QUALIFICATIONS REQUIRED OF OPERATORS
"Homogeneous" Operator (SPECIALISED TECHNICIAN)
Expert operator authorised for handling, transporting, installing, servicing, repairing and
scrapping the equipment.
Prohibition for the homogeneous operator to perform any type of operation (mainte-
nance and/or other) without having first read the entire documentation.
The information contained in this document is for the exclusive use of the qualified
technical operator who is authorised for: handling, installation and maintenance of
the appliance in question.
The technical operators must be trained on all the aspects regarding functioning
and safety. The technical operators must interact while respecting the required
safety standards.
Work areas and hazardous zones
To better define the scope of intervention and the relevant work zones, the following classification is provided:
• Dangerous zone: any zone within and/or in proximity to a machine in which the presence of an exposed per-
son constitutes a risk in terms of the health and safety of such a person;
• Exposed person: any person that is found wholly or partly in a dangerous zone.
Maintain a minimum distance from the appliance when operating in such a way as to avoid
endangering the safety of the operator in case of unexpected circumstances.
The heterogeneous operator must have read this document. In no event may they perform
control and maintenance operations that are the responsibility of specialised and author-
ised personnel (Homogeneous operator).
The following are also danger zones:
• All the work areas within the appliance
• All the areas protected by appropriate safety and protection systems such as safety photocell photoelectric
curtains, protective panels, interlocked doors, protective casing.
• All the zones within the control units, electrical cabinets and junction boxes.
• All the zones around the appliance in operation when the minimum safety distances are not being respected.
2.2 EQUIPMENT REQUIRED FOR INSTALLATION
The authorised technical operator, in order to perform the installation operations correctly, must respect the fol-
lowing requirements:
3 and 8 mm screwdriver
Flat-head screwdriver
medium sized Phillips-head
screwdriver
8 mm hex socket wrench
8 mm nut driver
In addition to the tools listed, an equipment lifting device is required. This equipment must
comply with all the regulations relating to lifting equipment.
THIS MANUAL IS THE PROPERT Y OF THE MANUFACTURER AND ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
Adjustable pipe wrench
and Electrician's scissors
Gas leak detector
MM 1" nipples
Gas use tools (hoses, gaskets etc.)
Water use tools (hoses, gaskets etc.)
Tools for electric use (cables, terminal
blocks, industrial sockets etc.)
Gas type change kit supplied by the
manufacturer
- 7 - 7