Publicité
Les langues disponibles
Les langues disponibles
Shutting down
Pull the red knob on the safety valve up
until the container is depressurized.
Empty the spray appliance and rinse it
with clear water.
Note
The choice and disposal of the spray liquid
depend on the instructions by the manufac-
turer.
1
1
1 Pump fastening screws
2 Pump collar
3 O ring, pump
4 Locking valve
5 Filter
6 Spiral hose
7 O ring, pressure bolt
8 Pressure bolt
Maintenance Works
After 50 uses, at least once per year:
Clean the nozzle under running water, if
necessary using a needle.
Figure 1:
Unscrew the fastening screws and dis-
assemble the pump.
Figure 2:
Lubricate the pump collar and the O-
ring with a little resin and acid free
grease.
Figure 3:
Remove filter between the shut-off
valve and the spiral hose and clean un-
der running water.
Figure 4:
Lubricate the O-ring with a little resin
and acid free grease.
Troubleshooting
The container is not building up
pressure
Check pump, screw in tightly.
Check the O-ring (see chapter "Care
and Maintenance") on the pump, re-
place the O-ring if defective.
Remove the remaining liquid from the
container.
Note
When pouring out via the fill opening, some
liquid will remain in the container.
Unscrew the spiral hose from the con-
tainer output and pour out the remaining
liquid.
Maintenance and care
2
3
2
Check the pump collar (see chapter
"Care and Maintenance") on the pump,
replace it if defective.
Liquid is escaping from the top of
Check, clean or replace the valve ring at
the bottom of the pump.
Nozzle will not spray, but pressure
Check and clean the filter (see Chapter
"Care and Maintenance").
Check, clean nozzle.
Safety valve blows off too soon
Safety valve defective, replace.
Shut-off valve does not close, liquid
escapes without activating the lever
Check or grease the O-ring (see chap-
ter "Care and Maintenance"), replace
the O-ring if defective.
Check the pressure bolt (see chapter
"Care and Maintenance"), replace it if
defective.
Manometer does not display any
container pressure
Replace manometer.
Accessories and Spare Parts
– Only use accessories and spare parts
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts en-
3
6
5
4
the pump
is there
Cleaning/storing the spray appli-
ance
Wipe the spray appliance with a damp
cloth.
For drying and storage, store the con-
tainer and the pump separately in a dry
area protected from sunlight and free of
frost.
4
7
8
sures that the appliance can be operat-
ed safely and troublefree.
– For additional information about spare
parts, please go to the Service section
at www.kaercher.com.
Technical specifications
Total content
Max. fill volume
Max. spray pressure
Max. operating temper-
ature
Unladen weight
Container material
Technical residual val-
ue
Max. volume flow
Recoil force
N
Warranty
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of your appliance within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication. In the event of a warran-
ty claim please contact your dealer or the
nearest authorized Customer Service cent-
er. Please submit the proof of purchase.
l
13
l
10
bar
6
°C
40
kg
4,7
Special
steel
l
0,03
I/min 0,78
below 5
7
English
Publicité
