Black & Decker BHSM15FX08 Mode D'emploi page 12

English
Cleaning

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the appliance.
These chemicals may weaken the plastic materials used
in these parts. Use a cloth dampened only with water and
mild soap. Never let any liquid get inside the appliance;
never immerse any part of the appliance into a liquid.
Accessories

WARNING: Since accessories, other than those offered
by BLACK+DECKER, have not been tested with this
appliance, use of such accessories with this appliance
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this appliance.
Recommended accessories for use with your appliance
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact BLACK+DECKER call
1‑800‑544‑6986.
Steam cleaning accessories
The performance of your appliance depends on the
accessory used. BLACK+DECKER accessories are engineered
to high quality standards and designed to enhance the
performance of your appliance. By using these accessories
you will get the very best from your equipment.
Garment steam cleaning (Fig. J)
(Available with BhsM15FX10)
NOTE: When first filled or after running dry, it can take up to
45 seconds for steam to be produced.
1. Fit the garment steamer sock
steamer attachment
2. Align the lugs 31 on the adaptor
on the garment steamer attachment
3. Press the garment steamer attachment
steam nozzle and twist counterclockwise as viewed
33
from the hand held steam unit until the accessory
clicks securely into place.
4. Connect the hand held steam unit to an outlet.
5. Press the On/Off button
down position.
nOTE: It takes approximately thirty seconds for the boiler
to heat up to operating temperature.
6. Once boiler is at operating temperature, press the required
steam flow button 28
7. When you have finished using the hand held steam unit,
press the steam flow button
flow, and turn OFF.
8. Wait until the hand held steam unit cools down for
approximately five minutes.
10
18 to the garment
.
17
9 with the recesses
17 .
onto the
17
so that the "i" is in the
1
or 29 to start the steam flow.
or to pause steam
28 29
On pole storage (Fig. L)
(Available with BhsM15FX10)
1. Clamp the on pole storage unit
extension pole
2. The adaptor
the on pole storage unit, as shown in Fig. L.
3. The bottom protrusion
can be used to store individual
attachments
Wall storage (Fig. M)
(Available with BhsM15FX10)
The wall storage unit
1. Wall bracket
2. Storage hook
and allows you to hang the cable tidily.
3. Storage box with lid
the wall bracket via the rail system provided. Any
accessories not being stored on the pole storage unit
can be stored in here.
Repairs

WARNING: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (including
power cord repairs, and brush inspection and
replacement, when applicable) should be performed
by a BLACK+DECKER factory service center or a
BLACK+DECKER authorized service center. Always use
identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
32
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of an
insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
• FOR YOUR sAFETY: Registering your product will allow
us to contact you in the unlikely event a safety notification
is required under the Federal Consumer Safety Act.
• Register online at www.BlackandDecker.com/NewOwner
onto the floor
23
.
7
9 can be stored in the opening in the top of
of the on pole storage unit
34
, , , or .
12 13 14 15 17
19 comes in three pieces:
20 which is screwed into the wall.
which is clipped onto the wall bracket
21
22 . This slides into place on
23