Axis Communications M31 Serie Guide D'installation page 6

Page 6
Install the hardware
1. Remove the top cover from the camera unit by loosening the 2
screws. Then insert a screw driver into the slit in the bottom cover
and lift.
2. Depending on the kind of installation required, follow the appropriate instructions below.
Mount the camera without adaptor
1. Adjust the drill template on the mounting surface so the
camera's lens faces in the right direction, and drill four holes for
the screws, and one hole for the cable.
2. Align the screw slots in the camera with the screw holes in the
mounting surface, and attach the camera with 4 screws.
Note:
It is recommended that each screw head with the washer does not
exceed 5mm in height and 7mm in diameter.
Do not use a countersunk screw head.
3. Attach the network cable to the camera's Ethernet cable.
Mount on a curved surface with an adaptor
1. Place the adaptor on the curved mounting surface, align
the two curvatures, and mark the two screw holes if
drilling is required.
2. Remove the protective paper from the adhesive tabs on
the adaptor by pulling the ends.
3. Place the adaptor in position and press down on the
adhesive tabs.
Note:
Fasten the adaptor to the surface with two screws if the
adhesive tabs do not stick to the surface material.
4. Place the drill template on the adaptor and turn the
camera lens in the direction you want the camera to
point.
5. Adjust the template to align the screw holes with the screw holes in the adaptor.
6. Mark the cable hole, and mark the four screw holes if drilling is required.
7. Drill the cable hole, and if required, 4 holes for the screws.
AXIS M31 Network Camera Series Installation Guide
curved surface
adaptor
adhesive
tab