Electrical Connection; Installation Notes - JUMO B 70.1050.0 Notice De Mise En Service

3

Electrical connection

3.1 Installation notes

- The choice of cable, the installation, the fusing and the electrical connection must conform to the requirements of
VDE 0100 "Regulations on the Installation of Power Circuits with nominal voltages below 1000 V" or the appropriate
local regulations.
- The electrical connection must only be carried out by qualified personnel.
- The electromagnetic compatibility (EMC) complies with the standards and regulations cited in the technical data.
Protect the instrument from electrostatic discharge during installation and operation.
- The instrument is not suitable for installation in areas with an explosion hazard and must be built into a housing that
provides protection against fire /electrical hazards.
- Apart from faulty installation, incorrect settings on the instrument (setpoint, parameter level data) may also affect the
proper functioning of controlled processes or lead to damage. Provision should therefore always be made for safety
devices that are independent of the instrument, e. g. overpressure valves or temperature limiters/monitors. Adjustment
must be restricted to specialist personnel (lock parameters for operation). Please observe the corresponding safety reg-
ulations in this matter. Unfavorable parameter adjustment may result in unstable control. The process value obtained
should therefore be monitored for its stability and knowledge about the process should be obtained.
- The load circuit must be fused for the maximum relay current in order to prevent welding of the output relay contacts in
the event of a short circuit.
- Do not connect any additional loads to the supply terminals of the instrument
- If contact with live components is possible while working on the instrument, it must be disconnected on both poles
from the supply (via a separate mains supply switch, for instance).
- Supply
230V AC and 115V AC
12 — 24V DC and 24V AC
short-circuit-proof
not short-circuit-proof
.
Measurement input and supply
electrically isolated from each other
not electrically isolated from each other
5