NEC MT1065 Mode D'emploi page 4

2. Keystone Correction at Zoomed Lens Position
You can zoom in or out, while keeping an image that was corrected using Keystone, without again having to make those adjustments.
Improvements in 3D Reform performance allows the projector's adjustment range (horizontal and vertical combinations) to be wider
by approximately 25% in the maximum telephoto position when compared to initial units shipped.
NOTE: There are some cases when adjusting the zoom position from Tele to Wide (after performing Keystone correction in Tele) can result in a
message "Range Over ! 3D Reform data has been cleared.". In this case correction values for Keystone will return to the factory default setting.
3. Using a USB Mouse
Selecting a Mouse Pointer Icon [Mouse Pointer]
This option enables you to select one of nine different mouse
pointers when using a USB mouse.
To display the "Mouse Pointer" setting screen, select "Menu"
→ "Page 1" → "Mouse Pointer".
Using the middle button on the mouse
The projector supports the middle button on your mouse. With the middle
button you can use a scroll bar when it is available or click the middle button
to display or hide the Chalkboard toolbar.
4. USB Memory Device or USB Memory Card Reader Support
The projector is compatible with either a USB memory device or USB memory card reader
which supports the viewer and security features.
• To use a USB memory device or USB memory card reader, connect the device to the USB
port (type A).
• Select one of the Drive icons in the Viewer toolbar, Capture toolbar and PC Card File setting
screen. Up to four drives can be accepted.
• To use a USB memory device as a Protect key for Security function, select one from the Drive
icons in the Security setting screen.
NOTE:
• Some USB memory devices (brands) or USB memory card readers may not work.
• You cannot use a USB memory device and a USB memory card reader when connecting a USB mouse to the projector.
Using a USB HUB that allows multiple USB memory devices or card readers is not supported either.
• Do not do the following while the USB memory device or USB memory card reader's access indicator is lit or flashing (while data is being
accessed.) Doing so can damage your USB memory device or USB memory card in the reader. Back up your data in case it will need to be restored.
* Pulling out the USB memory device or USB memory card reader from the USB port of the projector.
* Pulling out the memory card from the USB memory card reader
* Turning off the main power switch or unplugging the power cable.
• The drive for "USB 1-4" is displayed only when the USB memory device or USB memory card reader is connected to the projector. The drive for
"USB 1-4" may be displayed differently from the one in the USB memory card reader.
• Some USB memory devices (brands) or USB memory cards cannot be used as Protect key for the projector's Security function.
Middle button
E3
USB ( MOUSE/HUB )