Fein Slugger JME HoleMaker III Mode D'emploi page 21

OBJ_BUCH-0000000375-002.book Page 21 Tuesday, March 12, 2019 9:48 AM
Adjusting the stroke range (figure 11).
Hold the machine firmly with
CAUTION
one hand by the drill motor
when loosening the two fastening screws.
Loosen both fastening screws using a hex key.
Adjust the desired stroke range.
Tighten both fastening screws again.
Fig. 11
6 mm
4.
2.
2.
4.
6 mm
3.
2.
1.
2.
en
21
3.
1.
4.
4.