Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Risk of sudden starts . Can cause electrical
shock and personal injury. If power to pump is on
when thermal overload resets, pump may start without
Check to be sure that the power cord is securely plugged into outlet. Disconnect power to outlet before handling pump or motor.
Check to be sure you have electrical power.
Check that liquid fluid levels is high enough to activate switch or controller.
Pump fails to
operate
Check to be sure that 3/16" (4.7mm) vent hole in discharge pipe is not plugged.
Check for bloackage in pump inlet, impeller, check valve or discharge pipe.
Thermal overload may have tripped. Test start pump; if it starts and then stops immediately, disconnect from power source for 30 minutes to
allow motor to cool, then reconnect to power source. Check for cause of overheating/overloading.
Be sure all valve in discharge are fully open.
Clean out discharge pipe and check valves.
Pump fails to
empty sump
Check for blockage in pump inlet or impeller.
Pump not sized properly. A higher capacity pump may be required.
Check switch or controller automatic floats for proper operation and loaction. See installation instructions for switch/controller.
Pump will not
shut off
If pump is completely inoperative or continues to malfunction, consult your local serviceman.
Cord Lift Warning
WARNING
Risk of electrical shock .
Can shock, burn, or
cause death.
Do not lift pump by
power cord.
For parts or assistance, call Flotec Customer Service at 800-365-6832
warning. If you are working on pump, you may get an
electrical shock or impeller may catch fingers or tools.
Disconnect power before servicing pump.
1. Attempting to lift or support pump
by power cord can damage cord and
cord connections.
2. Cord may pull apart, exposing bare
wires with possibility of fire or
electrical shock.
3. Lifting or supporting pump by power
cord will void warranty.
4. Use lifting ring or handle on top
of pump for all lifting/lowering of
pump. Disconnect power to pump
before doing any work on pump
or attempting to remove pump
from sump.
1476 0195
5
Publicité
