Safety Tips - Steba VG 400 BIG Mode D'emploi

Generally
This appliance is for private use only and must not be used commercially. Please read
the instruction manual carefully and keep it at a safe place. When the appliance is
given to another person the instruction manual should be passed to that person, too.
Only use the appliance as described in the instruction manual and pay attention to
the safety information. No liability for damages or accidents will be accepted, which
are caused by not paying attention to the instruction manual.

Safety Tips:

∙ The device must be plugged in and used according to the rating label regulations.
∙ Only use the device when the power cord is without any damage. Check before
each use.
∙ Keep the power cord away from hot surfaces.
∙ Unplug the device after each use, when you leave the room or at any malfunction
of the device.
∙ Keep the power cord away from hot surfaces and do not pull it over sharp edges.
∙ Never use this item without attendance.
∙ This appliance is not intended for use by persons (including children)
with reduced physical, sensory, or mental capacities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety
∙ Children should be supervised to ensure that they do not play with the appliance or
the packaging.
∙ The appliance is not intended to be operated by means of an external timer or
separate remote control system.
∙ Important: Never immerse the thermostat element or the power cord into water!
∙ Only use the device for food preparation
∙ Never use the device after a malfunction, e.g. when it was fallen down or was
damaged in any way.
∙ To avoid any dangers must repairs, e.g. change of a defect power cord, only be
done by our service or an authorised company.
∙ Device gets hot. Only transport after it cooled down.
∙ If the appliance is used as a table top, it must be placed on a even, stable and heat
resisting surface (e.g. Not on painted furniture) and keep away (min 70cm) of bur-
nable materials (e.g. curtains)
∙ Before the first use: Clean all parts and dry them afterwards. To get rid of the new
smell, heat up device for 15 minutes with top closed. Apply a light coating of coo-
king oil to griddle beforehand. After cooling, wash griddle in soapy water and dry.
∙ Attention! Housing and glass get hot, Risk of burns!
Don´t place the device on a sensitive surface (e.g. painted furniture)
and keep distance of at least 70 cm to burnable materials (e.g. curtains).
∙ The appliance should be supplied through a residual current device (RCD) having a
rated residual operating current not exceeding 30mA.
∙ The connector shall be removed before the appliance is cleaned and that the appli-
ance inlet must be dried before the appliance is used again.
8
Stand assembly:
Attach short tube to base with slot facing downwards, fit shelf and engage, then
screw on the short tube. Then fit the lower body.
Installation of lower body:
Put on the lower body reversed left to right.
Insert the two handles into the provided receptacle in
the lower body.
Attach curved handle sections using the screws.
Then fit lower body to stand.
Assembly Lid
Lid attachment:
To use the lid as a windbreak or for putting items onto
when grilling, it can be hooked onto the handle.
Washer Nut
Screw Thermometer
9